Haier XPB72-0715S, XPB72-0714D user manual Rinsing Spinning, Cleaning the overflow filter

Elastic fixing claw

Rinsing

Spinning

Disposal after washing

• After using, please clean the lint and foreign materials of the lint filter

and over flow filter in time. Otherwise it may influence your using the

machine.

Cleaning the overflow filter

Rinse with water-filling

1.Put the laundries into the wash tub. Select suitable wash speed according to the laundries.

2.Adjust the water level

Set the water level with water level adjusting lever according to the laundries quantity. Then fill suitable water continuously.

3.Rinse

Adjust the wash timer to 5-7 minutes to do rinsing.

(Repeat the midway spinning and rinsing with stored water for 2-3 times)

Rinse with stored water

1. Put the laundries into the wash tub. Select suitable wash speed

1.Put the laundries into the spin tub evenly and smoothly.

2.Press the gland in the tub properly. Close the inner and outer cover of the spin tub.

3.Spin

Select suitable spin time according to the laundries, and do spinning.

During spinning, if there's abnormal sound, it is generally owing to slanting placement of the laundries. Please stop the machine and re-order the laundries.

•In spinning, it will pause the work if you open the outer cover of the spin tub. Close it to resume the spinning.

• Please first pull off the power plug from the receptacle before

cleaning.

Cleaning the lint filter

• The lint filter must be used during washing.

• It must be cleaned in time after each using.

1. Take off the lint filter

Put hand at the indicated position.

Push down to take it off.(See to Figure 1)

Figure 1

2. Clean the lint

Put it in water and clean while it is

still wet. (See to Figure 2)

3. Install the lint filter
After	cleaning ,	insert	the	Figure 2
bottom of the lint		filter (marked

with "down side ") into the overflow filter.

1.Take off the corrugation pipe. Dismantle the upper part of the

corrugation pipe inside the overflow filter (as indicated in Figure1)

2. Cleaning the overflow filter.

Clean the lint around the filter and flush with tap water.

3.Install the overflow filter.

(a)Install the corrugation pipe.

(b)Insert the mounting plate at the bottom of the filter into the valve cover.

(c)Hang up the book at the left upper side.

(d)Push the upper part in as indicated in Figure 2.

Water level adjusting lever

Corrugation pipe

Figure 1

Hook

Figure 2

Semi Automatic Washing Machine

User's manual

This manual is for

according to the laundries.

To do spinning and draining

then push the upper part of the filter in

Disposal of the complete unit

2.	Fill water to preset water level.
3.	Rinse
	Adjust the wash timer to 2-3 minutes to do rinsing.
•	When the laundries quantity is a few, please	use "Standard"
	wash speed. If you use "Strong" wash speed,	it may splash.

or rinsing with water-filling

together, please first do

spinning for around 1 minute,

then do draining or rinsing

with water-filling. Otherwise

the spinning will stop owing

to too much water stored in

the spin tub.

(marked with "up side"). (See to Figure 3) Figure 3

Cleaning the overflow filter

• Too much lint on the overflow filter will influence the normal usage of the machine. Please clean it every two months.

• Take off the overflow filter.

As indicated in the figure, nip the elastic fixing claw and pull it to the direction of the arrow to take it off.

•Wipe the complete unit with soft cloth twisted dry.

•Wipe with neutral detergent if too dirty.

•Do not wash it directly by water.

Petrol Thinner

Alcohol

•After washing, dismount the water inlet hose.

•Do not store water in the tub for long period. Discharge the water immediately after each using.

•Pull off the power plug and hang up the power cord.

•Hang up the drain hose.

Wipe off the water drops on the surface and inside the tub with clean soft cloth.

•Open the cover of the wash tub and

the inner/outer cover of the spin tub for some time (about one hour), then close them.

XPB72-0713S

XPB72-0714D

XPB72-0715S

Please read this manual

carefully before using.

Retain it for future reference.

10

Trouble-shooting Answer to question

If the laundries fall to the outer side of the spin tub

If the laundries fall to the outer side of the spin tub, please take

them out immediately.

11

Trouble-shooting Answer to question

(If there's breakdown, please pull off the power plug before checking) The following phenomena are not breakdowns sometimes. Please confirm again before sending it to repair. If there are real breakdowns, Please come to the special maintenance department or after-sale service department of our company. Do not repair it by yourself.

Phenomena The reason

12
Packing list
Name	Quantity
User's manual	One piece
Warranty manual	One piece

13

Customer Name	................................................................................... Address	..................................................................................
Serial No	Date of purchase	Model No
Inspired Living
Dealer Seal

H A I E R WA R R A N T Y

HAIER APPLIANCES (INDIA) PVT. LTD. ( hereinafter referred to as "the Company") hereby offers the following warranty to the original domestic purchaser commencing from the date of the purchase. The Company, at its sole discretion, will free of charge repair or replace any defective part or parts which prove to be defective in workmanship and/or materials and not due to abnormal or improper usage.

CONDITIONS OF WARRANTY

When the remained water is frozen

•Prevent the freezing(be sure to discharge the water completely after using)

•After complete draining, set the " WASH SELECTOR" at "STRONG" or "STANDARD". If it is set at "DRAIN", it will be rather difficult for the frozen water to melt.

	• Is there power failure?
The machine does	• Is the power plug loose?
not act.	• Is the pulsator twisted by foreign
	materials?
	• Is the drain hose put down?
	• Is the drain hose frozen?
The draining does	• Is the drain hose blocked by foreign
not work.	material?

Water inlet hose	One piece
Lint filter	One piece
Gland	One piece

1)This warranty will automatically terminate on the expiry of the warranty period from the date of delivery.

2)The Company is not liable for any delay in servicing due to reasons beyond the control of the Company or any of its authorised service centres.

3)Parts replaced or repaired under this warranty are warranted throughout the remaining of the original warranty period.

4)It is entirely lelf to the Company's discretion to repair/replace parts at the site of installation or at the authorised service centre of the Company.

Product	Warranty
	Period	Parts not covered
Colour TV	12 Months	Remote, Cabinet
Refrigerator	Comprehensive: 12 Months	Plastic, Glassware,
	Compressor: 60 Months	Light bulb
Washing Machine	Comprehensive: 24 Months	Top Lid, Outer
	Motor: 60 Months	Casing
Airconditioner	Comprehensive: 12 Months	Air Filter, Front Gril
	Compressor: 60 Months
Microwave	12 Months	Glass, Plate, Bulb
Dishwasher	24Months
Cloth Dryer	12 Months
DVD	12 Months

Below 50°c 2-3L

•When the water is frozen

Pour hot water below 50°C into the wash tub to soak it completely. Then turn the pulsator with hands gently. Please confirm the drainage can work normally before next using.

14

	• Are there laundries falling to the outer side
		of the spin tub?
There's abnormal	•	Are	there	hair pin, coins	or	metal items
sound during		brought inside the tub?
washing
There's abnormal	• Is the machine slanting?
	•	Is the gland pressed evenly?
sound and violent	•	Are	there laundries falling to the outer side
vibration during		of the spin tub?
spinning.	•
		Are the laundries in spin tub too much?
There may be some
water flowing out of	•	It is	the	water remained	in	the factory
the drain hose in
		inspection of performance.
the first use of the
machine.

15

Twin-tub washing machine One set

Specification

Water level /Water quantity (L) (about)	Maximum/58	Medium/49 Minimum/43
Injection pressure (MPa)	0.02 0.2
Washing / Spinning capacity (kg)		7.2 / 6.0
Dimensions (mm)	L 786	W 455 H 945

16

5)This warranty shall be strictly

limited to the repairs or replacement of defective parts specified in the warranty. This warranty shall not cover any consequential or resulting liability.

6)This warranty shall not, in any case, extend towards payment of any monetary consideration whatsoever or replacement or return of the product.

7)The Company may repair/supply parts free of cost during the warranty period. This warranty does not cover any Excise duty.Central or Sales tax, Octroi and other local taxes or levies on the components/parts.

8)The parts shall be replaced by functionally operating equivalent material only and not with brand new ones and are likely to be different from the one originally fitted.The parts thus removed shall be taken back by the company.

9)The Company reserves th right to retain any part or component replaced at its sole discretion during the warranty period.

10)In no event the Company or its authorised service centre be liable for any consequential damages or resulting liability, damage or loss arising directly or indirectly out of any defect in the product.

11)This warranty is not valid in case of the following events:

a)If the product has been installed/serviced/repaired/opened or tampered by any unauthorised personnel.

b)If defects arise/caused by accidents, alteration, misuse, neglect, sunstitution of original components with spurious/non-genuine components, attacked by household pest/rodents, fire flood, earthquake, lightning and/or any other act of God/natural calamities.

c)The product is shifted outside India.

12)For any service under this warranty beyond city/town/municipal limits from the Company /authorised service centre, a fixed charge of Rs. 50 will ne collected from the customer in addition to the actual to and fro charges by the shortest route.

13)Any change of location or change in the ownership during the warranty period must be intimated in writing to the Company.

14)The Company's employees or its authorised representatives have no authority to vary the terms of this warranty.

15)This warranty is effected in New Delhi and claims, if any, shall be made only before the courts having jurisidiction in New Delhi and no claim shall be made against the Company outside New Delhi notwithstanding that the Appliance may have been sold or delivered elsewhere.

HAIER APPLIANCES (INDIA) PVT. LTD., B-1/A-14, Mohan Co-operative Industrial Estate, New Delhi-44 Ph. 30674000/5000, Fax: 011-26971562

	Customer Name	................................................................................... Address	..................................................................................
Inspired Living	Serial No	Date of purchase	Model No
	Dealer Seal

Haier Appliances (India)P. Limited

B-1/ A-14, Mohan Co-operative Industrial Estate, Mathura Road, New Delhi-110044.

Tel: 011-30674000/5000. Fax: 011-26971562. Email: info@haierindia.com Website: www.haierindia.com

Gripper - Haier Manua Revised (correction) - date - 31 - 5 -2010