At the last spinning, it stops spinning, turns to rinse
and inlets water.
The reason is that the laundries leaning to one side,
so the safety switch acts. After inleting water, churning
up , the slant has been eliminated, then spinning again.
There is still water after draining
for 5 minutes(the indicator light
of soak, wash, rinse, spin flashing).
Troubleshooting Answer to question(If there's breakdown, please pull off the power plug before checking) The following phenomena
are not breakdowns sometimes. Please confirm again before sending it to repair. If there are real
breakdowns, please come to the special maintenance department or after-sale service department
of our company. Do not repair it by yourself.
Phenomenan The reason How to settle
In rinsing, spinning, the
machine stops running.
(The indicator light flashing)
Close the top lid.
The top lid is not closed.
Is the drain hose put down?
Is the drain hose blocked by
foreign material? Clean the foreign material .
Open and close the top lid once.
Put down the drain hose.
Open and close the top lid once.
The safety switch acts. The
spinning can not work ( the
rinse, spin light flashing)
Are the laundries put slantingly? Re-order the laundries. Close the top lid.
Is the machine slanting? Level the machine in right position.
Open and close the top lid once.
It does not do water inlet or
the speed is slow ( the water
level is not reached after 20
minutes. The wash rinse is
flashing).
Is the water faucet open ?
Is the water inlet valve blocked? Clean the water inlet valve .
Open and close the top lid once.
Open the water faucet.
Open and close the top lid once.
Is the hydraulic pressure too low?. Please use the machine after the
hydraulic pressure reached to the
rating.
the machine
does not act
No washing
No spinning
Is there power failure?
Is the power plug loose?
Does the water reaches the preset
level?
Is the power plug loose?
Is the top lid closed?
Are the laundries Distributed
evenly?
Use it when the power is on.
Insert the power plug tightly.
Fill water to the preset level.
Distribute the laundries evenly.
Insert the power plug tightly.
Close the top lid
There's abnormal sound inside
the machine.
Is the machine slanting?
Are the laundries slanting in spinning?
Level the machine properly.
Re-order the laundries. Close the top lid.
The water faucet leaks. Is the jointer screw of the water inlet
hose loose or twisted awry? Fasten the jointer screw properly.
Common phenomena
The spinning is intermittent when it starts. Balance the laundries to avoid slanting.
Phenomena Explanation
Select the SPIN program, but it doesn't work. The program is setting the drain time. Some time is needed
before it starts spinning.
There may be some water flowing out of the drain hose in the first
use of the machine.
It is the water remained in the factory inspection of performance.