Haier XQB100-96 Installation and adjustment, Before Using

Installation and adjustment

Please install and adjust the machine according to the requirement of the manual. It is

very important to your security and correct operating the machine.

The largest allowed slope of the base of the machine is 2 . The slanting or rough

ground will result in unstable running or stoppage of the machine. Please adjust

it with following methods:

Confirm it's horizontal:

Hang the lead line to confirm

if it is horizontal.

Adjust the adjustable foot:

1.To twist the adjustable foot, please first lift up

the side of the foot slightly, and twist the foot.

2.Fasten the nut after adjustment.

High Low

Adjustable foot

Put the drain hose clamp on the outer drain hose,

insert the outer drain hose into the joint for it, and

then clutch tightly with drain hose clamp.

Drain hose joint

Drain hose clamp

Drain hose

If the drain hose is too long, cut it at mid

point. To make smooth drainage, cut the

front end of the hose slantingly.

4.If extra drain hose is needed, please

make separate purchase. The inner

diameter of the extra hose shall not

less than 30mm, and the length shall

not exceed 1.5m.

1.The height of the drain hose shall be

less than 10cm, or the drainage will not

be smooth, and cost such long time that

the machine may stop at mid way.

2.Do not tramp or press the drain hose.

The drain hose shall drain smoothly

Before Using Before Using

After opening the package, please take out the lint filter

from the document bag and install it into the frame of

the inner tub. See to the right Figure.

Filter frame Lint filter