Maintenance
Installation
Connection of water inlet hose and washing machine
1. Turn of the water and electricity supply | 2. Unplug the machine during cleaning and | ||
after every wash. Open the door to pre- | maintenance. Use a soft cloth dampened with | ||
vent the formation of moisture and odors. | soapy liquid to clean the machine case and rub- | ||
If the washing machine is left idle for a long | ber components. Do not use corrosive or abra- | ||
period, drain any remaining water in the | sive chemicals or solvents. | ||
machine and replace the drainage hose. |
| ||
|
|
|
|
3. Clean the detergent compartment | 4. Cleaning the Filter (once a month) | ||
regularly. For the detergent compartment |
| ||
similar to figure (a), raise the compartment | Press the lower edge of the filter compartment | ||
slightly to remove and replace after cleaning. | cover to open; | ||
|
|
| Remove the filter by turning counterclockwise; |
|
|
| (Fig3) |
|
|
| Flash clean with running water; |
|
|
| Filter replacement is the reverse of removal. Cau- |
|
|
| tion: Attention shall be paid to ensure that the filter |
|
|
| |
|
|
| is replaced correctly to avoid possible leakage. |
Fig (a) | fig.1 | fig.2 | fig.3 |
Water drainage hose
= The height of the terminal of the water drainage hose should be between
Use the water drainage support supplied as an |
accessory for proper installation of the water drain- |
age hose .fix the water drainage hose support with |
waterproof sring.Do not use an excessively long wa- |
ter drainage hose and contract the authorized tech- |
nician if the water drainage hose needs to be |
extended.the water drainage hose should not be ex- |
tended more than250cm.(longer extension will result |
in concurrent water inflow and outflow).The diam- |
eter of the extension hose should be the same as |
the original hose. |
caution:water drainage hose must not be immersed |
in water.the original and extension hoses should be |
NMMÅã UMÅã |
5.To prevent block- ages to the water sup-
ply or the ingress of contaminants, clean the water inlet and in- l e t w a t e r f i l t e r regularly.
7.If the washing machine is left idle for a long period turn off the water and electricity supply and open the door slightly to prevent the formation of moisture and odors.
6.If the machine is to be moved a distance location, replace the vibration mounting locks which were re- moved during installation as shown below.
Remove the back Replace the rubber Insert the bolts.
cover. plugs.
|
|
|
|
|
|
| Replace the back |
Tighten the bolts with a |
| ||
spanner. |
| cover. | |
tightly connected . |
Connection of power supply
Check the following items before connection to the power supply.
==The socket conforms to the maximun power load(The maximum current load of the socket and power supply cable should not be less than 15A)K
Power supply voltage conforms to the required value.
==The power supply socket and the plug of the washing machine compatible,if they are not com- patible ,Refer to a washing machine technician or a Haier designated service point for power cable replacement.The washing machine should be connected to an earth before use.
= Supplementary earth cable should not be necessary if the socket is connected to the earth. = Supplementary earth cable should be installed on the upper back of the washing machine andconnected to an earth if the power supply socket has no earth connection.
12 | 5 |
