Models OVL-II SER-Q- OVL-II ESR-Q, Standard Configuration

OVLERQ*C OVLSRQ*C OVLESRQ*F OVLSERQ*F

Models

OVL-II SER-Q – OVL-II ESR-Q

1. Cut a rectangular wall opening 37-1/2” (953 mm) W x

		37-3/4” H (959 mm) and 4-1/2” (114 mm) above the
		floor line (see Figure 7). The dimensions are required
		to obtain proper rim and bubbler heights for
		compliance with ANSI standard A117.1.
		2. Reinforce the wall opening on all sides to adequately
		support the water fountain. This reinforcement must
		support up to 150 lbs. static load and provide a
		means for securing the frame assembly in place.
		NOTE: Building construction must allow for
		adequate air flow on both sides and top of
		remote chiller unit a minimum of 4” (102
		mm) is required.
		3. Install plumbing and electrical rough-ins. A junction
		box for a (3) wire, 10 amp branch circuit is provided on
		the inside of the chiller. (Standard 120 Volts, 60 Hz,
		and single phase.)
	Figure 6 – OVL-II SER-Q Rough-In	4. Remove frames and related hardware from
	Figure 6 – OVL-II SER-Q Rough-In	packaging. Release the two shelf rods by cutting
		packaging. Release the two shelf rods by cutting
		cable ties. Attach the two frames together through the
		upright supports with (4) 5/16” x 3/4” (19 mm) long
		bolts and nuts (not provided). Tighten securely.

REVERSED CONFIGURATION:

HIGHER UNIT ON THE RIGHT

HIGHER UNIT ON THE LEFT

Figure 7 – Rough-In Assembly

Dual-Station Mounting Frames

97793C - 10/01