840082000 Ev01.qxd 2/22/01 9:57 AM Page 5
How to Insert Attachments
Each set of attachments must be inserted into the proper hole in the Mixer Head. They are not interchange- able; there is a right and a left. Beneath the collar is etched a small R or L. This indicates the correct hole to place attachment. The “RIGHT” side of the Mixer is the side with the Sensor Speed control. The beater marked R, with
Mixer Head Graphics
the flat bottom, should be placed in the hole on the right side of the Mixer first. Insert attachment into hole and turn slowly until tabs slip into slots in hole. Push in until attachment locks in place. Then insert the beater marked L, with the rounded bottom. If difficult to insert, turn beater one quarter turn and try again.
Left | Right |
How To Use Your Stand Mixer
1.Before using, wash bowls and attachments in hot, soapy water. Rinse and dry.
2.Make sure the Mixer is turned to OFF and unplugged.
3.Place small post on bottom of Turntable in hole on Mixer Base that matches bowl to be used.
4.Press the Mixer Release button and raise the Mixer Head up.
5.The beaters and dough hooks must be inserted into specific holes in the Mixer Head. See “How to Insert Attachments.”
6.Place bowl onto Turntable. To lower Mixer Head, first raise Mixer
Head slightly and press Mixer Release button to release. Lower into bowl. When lowered, the Mixer Head automatically locks into place.
7.Plug cord into electrical outlet. Select desired speed. Prepare recipe according to instructions.
8.When finished, turn Sensor Speed Control to OFF. Unplug from outlet.
9.Press Mixer Head release button, raise Mixer Head until locked into place.
10.Press Beater Eject Button to remove attachments.
Sensor Speed™ Guide
This is an illustration of the Sensor Speed Guide on your Mixer. The guide may help you select a speed for most mixing tasks. These guides are recommendations. Please adjust Mixer speed as needed.
5
