Troubleshooting
PROBLEM
Machine will not work when switched ON.
Motor appears to stall when juicing.
Excess pulp building up in the
Pulp is too wet and insufficient juice is produced.
Juice sprays out of spout.
Juice drips out of spout immediately after juicing.
Machine vibrates excessively.
PROBABLE CAUSE/SOLUTION
•The locking latches may not be correctly engaged. Check to see if the locking latches are properly positioned in the two grooves on either side of the juice cover. Refer to page 5, Steps 3 and 4.
•This machine is equipped with motor overload protection. If the motor stops during operation due to overheating, unplug and allow it to cool down for 15 minutes. Plug machine back in after 15 minutes to resume normal operation.
•The juicing action may be too vigorous. Try slower juicing action by pushing the food pusher down more slowly. Refer to page 6, Step 3.
•Wet pulp can build up under the juicer cover or pulp container. Turn unit OFF and unplug. Empty the pulp bin; then clean juice cover and strainer basket.
•Turn OFF and unplug. Remove strainer basket and clean mesh walls with a fine brush. This will remove excess fiber buildup which could be inhibiting the juice flow. Refer to pages 7 and 8.
•Try a slower juicing action.
•Turn OFF and unplug. Remove strainer basket and clean mesh walls with a fine brush. This will remove excess fiber buildup which could be inhibiting the juice flow. Refer to pages 7 and 8.
•Try a slower juicing action by pushing the food pusher down more slowly. Refer to page 6, Step 3.
•With motor ON, raise and lower food pusher in feed chute several times. The action forces remaining pulp and juice out of strainer bowl.
•Buildup of pulp in mesh of strainer basket. Turn unit OFF and unplug. Clean strainer basket. Refer to page 8. If machine vibration continues after cleaning, this could be a sign of a damaged strainer basket. Call our
10
840148105 ENv01.indd 10 | 9/23/13 2:19 PM |
