Hamilton Beach 840115800, 04152 manual Installing the Carbon Pre-Filter, Setting the Controls

840115800 ENv00.qxd 6/6/03 9:02 AM Page 6

Installing the Carbon Pre-Filter

4	Insert the two tabs on the
	bottom of the intake grille into

1

2

NOTE: The carbon pre-filter should be replaced approxi- mately every three months.

Remove the intake grille by carefully pulling the upper two side tabs away from the body of the air purifier and lifting up.

Locate the black carbon pre-filter. It will be folded inside a plastic bag. Remove and discard the plastic bag.

the holes on the bottom ledge of

the air purifier. Pivot the intake

grille into place and lightly press

on the upper corners of the grille

to snap it into place.

NOTE: The air purifier has a safety switch that prevents operation if the intake grille is not properly installed. DO NOT attempt to override or disable this safety switch.

Setting the Controls

3

Unfold and flatten out the black carbon pre-filter. Attach the four corners of the carbon pre-filter to the four hook fasteners on the HEPA filter.

1.Power On Indicator – Lights when unit is on.

2.Fan Speed Knob – Turn the fan speed knob to the desired setting. There are four settings:

•OFF

•WHISPERCLEAN™ – Use for quiet, nighttime operation or for constant low-speed filtra- tion.

•MED (Medium) – Provides a higher fan speed; use for quickly filtering dust, pollen, smoke, etc. from a room.

•QUICKCLEAN™ – Provides cleaning during acute needs.

WARNING: To reduce the risk of electrical shock, never plug in the air purifier while your hands are wet. Always unplug the air purifier before moving or servicing the unit.

6 7