Hamilton Beach DE-301/331, DE-302/304/332/334 manual Network Connection

The next step is to attach NPort Server Lite to the Din Rail.

STEP 1: Insert the top of the DIN Rail into slot A of the DIN Rail mount.

STEP 2: Push the bottom of NPort Server Lite so that the bottom of the DIN Rail snaps into slot B of the DIN Rail mount.

To remove NPort Server Lite from the DIN Rail, simply reverse Steps 2 and 3 above by grasping the bottom of the NPort Express device server with both hands, and then using your fingers to pull down slightly on the DIN Rail mounts at slot B. This releases the bottom of the DIN Rail from the DIN Rail mount.

Network Connection

There are two ways to use the 10/100BaseT Ethernet jack located on NPort Server Lite’s rear panel.

1.For many of the applications using NPort Server Lite, you will simply plug one end of your Ethernet cable into the 10/100BaseT jack, and the other end into the hub connected to your network. In this case, use a standard straight-throughEthernet cable.

2.In some cases, such as when configuring drivers and software, you will find it convenient to hook NPort Server Lite directly to your computer’s Ethernet card. To do this you will need to use a cross-overEthernet cable, such as the one supplied with your server.

2-5