Hamilton Beach Troubleshooting Guide, Maintenance, Replacement Parts for Model HBB908, Problem

Caring for the Blender

Troubleshooting Guide

Problem . . .	Solution . . .
Blender fails to start	• Check to see if unit is securely plugged into an electric outlet.
or stops while it is	• Check to see if the fuse for the electric outlet has blown or if a circuit breaker
running and cannot
	has tripped.
be restarted
	• If the motor stops during operation due to overheating, unplug and allow the
	blender to cool down for 15 minutes. Plug blender back in after 15 minutes to
	resume normal operation.
Ingredients will not	• Check to see if enough liquid has been added to the ingredients. Mixture should
mix properly	be fluid and free-running at all times.
	• Solid pieces are too large. Pieces should not exceed 1″ (25-mm) cubes.
	• Container is too full. Do not fill past highest graduation marking.
	• Cutter unit blades are not sharp or are damaged. Inspect container and cutter
	assembly daily. Replace cutter assembly at least every 90 days or sooner if
	cutter assembly appears worn or damaged.
	• Check to see if cutter assembly is installed properly.
	• Select speed to create a fluid blend.

Maintenance

Inspect the blender and its various parts and replace as follows:

Daily	Unplug the blender, remove the container from the base, and then inspect the container
	and cutter unit assembly for wear, nicks, and broken or loose blades. Replace if
	necessary. If the blades are loose, discontinue use immediately and replace the blades.
	Do not attempt to repair or tighten the cutter assembly. See “Replacement Parts” below.
Weekly	Unplug the blender, and then inspect the power cord insulation and power plug for
	cracks. Refer to “Technical Service” on page 2 for repair or replacement.
Quarterly	Replace the container and cutter assembly at least every 90 days. See “Replacement
	Parts” below.

Replacement Parts for Model HBB908

For replacement parts, call toll-free: 866-285-1087.

Part Description	Part Number
44-oz. polycarbonate container	6126-HBB908
Cutter assembly	98908

9