Installation guidelines
Figure 1: Always leave sufficient slack in the lines to pull enough of the reservoir out of the drive bay and uncover the fill port.
Figure 3: The minimum operating fluid level is at the mould parting line.
Figure 5: Desired (Maximum) operating fluid level
Figure 2: You can start filling up the reservoir while it is in the drive bay, using a household funnel. Then,
Figure 4: If possible or desired, you can also fill the reservoir outside of the chassis. Tipping it steeply at an angle will allow you to
Figure 6: Once full, secure the reservoir to the
IMPORTANT DISCLOSURES
While all efforts have been made to provide the most comprehensive tutorial possible, Swiftech assumes no liability expressed or implied for any damage(s) occurring to your components as a result of using Swiftech cooling products, either due to mistake or omission on our part in the above instructions, or due to failure or defect in the Swiftech cooling products. WARRANTY Our products are guaranteed for 12 months from the date of delivery to the final user against defects in materials or workmanship. During this period, they will be repaired or have parts replaced provided that: (I) the product is returned to the agent from which it was purchased; (II) the product has been purchased by the end user and not used for hire purposes; (III) the product has not been misused, handled carelessly, or other than in accordance with any instructions provided with respect to its use. This guarantee does not confer rights other than those expressly set out above and does not cover any claims for consequential loss or damage. This guarantee is offered as an extra benefit and does not affect your statutory rights as a consumer.
Copyright Swiftech 2004 – All rights reserved – Last revision date:
Rouchon Industries, Inc., dba Swiftech – 1703 E. 28th Street, Signal Hill, CA 90755 – Tel.