9. Place the downrod ball into the hanger bracket socket. (Fig. 8)
2. Remove the hanger bracket from the canopy by loosening the four screws on the top of the canopy. Remove the two non-
slotted screws and loosen the slotted 8. Tighten two set screws on top of the fan screws. This will enable you to remove the motor firmly. (Fig. 7)
hanger bracket. (Fig. 5)
WARNING
FAILURE TO PROPERLY INSTALL LOCKING PIN AS NOTED IN STEP 7 COULD RESULT IN FAN LOOSENING AND POSSIBLY FALLING.
1. Remove the canopy ring from the canopy. (Fig. 5)
STANDARD CEILING INSTALLATION
3. Pass the 120-volt supply wires through the center hole in the ceiling hanger bracket as
REMEMBER to turn off the power. Follow the shown in Fig. 6.
steps below to hang your fan properly. NOTE: 4. Secure the hanger bracket to the ceiling This ceiling fan is supplied with two types of outlet box using screws and lock washers hanging assemblies; the standard ceiling included with your outlet box. (Fig. 6) installation using the downrod with ball and
socket mounting and the "flushmount" 5. Remove the hanger pin, lock pin and set installation. The "flushmount" installation is screws from the top of the motor assembly. recommended in rooms with less than 8-foot
ceilings or in areas where additional space is 6. Route wires exiting from the top of the fan desired from the floor to the fan blades. When motor through the canopy ring. Make sure the using the standard 4 1/2" downrod, the widest edge of the canopy ring are on top. distance from the ceiling to the bottom of the Route the wires through the canopy and then fan blades will be approximately 12 1/2 through the ball/downrod assembly (Fig. 7). inches. The "flushmount" installation reduce
this distance to 8-inches. Once you have 7. Align the holes at the bottom of the downrod selected which mounting system you will use, with the holes in the collar on top of the motor proceed with the following instructions. Where housing (Fig. 7). Carefully insert the hanger pin necessary, each section of the instructions will through the holes in the collar and downrod. Be note the different procedures to follow for the careful not to jam the pin against the wiring
two types of mounting.inside the downrod. Insert the locking pin through the hole in locked position, as noted in the circle inset of Figure 7.
Hanging the Fan
Ceiling mounting bracket
Screws
Ceiling canopy
Canopy ring
Figure 5
UL Listed 
electrical box
Hanger
bracket
Tab
Mounting screws 
(supplied with 
electrical box)
Figure 6
4.
