Hampton Bay 171-889, 172-503, 171-348, 170-721, 176-925 owner manual Flushmount Installation

Motor wires

Ball/downrod assembly

Ceiling canopy

Canopy ring

Tighten screws firmly

Locking

Hangerpin pin

Figure 7

FLUSHMOUNT INSTALLATION

1.	Remove the decorative canopy cover from
the canopy. (Fig. 9)
2.	Pass the 120-volt supply wires through the
center hole in the ceiling hanger bracket as
shown in Fig. 6.
3.	Secure the hanger bracket to the ceiling
outlet box with the screws and washers
provided with your outlet box. (Fig. 6)
4.	Tighten the two screws on the outlet box
securely.
5.	Remove three of the six screws and lock
washers (every other one) from the collar of
top motor (Fig. 10)
6.	Place the rubber gasket over the remaining
three screws, route the wires exiting the top of

8.Hang the fan on the hook of the hanger bracket. Be certain that the canopy is fully locked into hook as shown in Fig. 11. This will allow you to make the electrical connections.

Canopy

Canopy cover

Figure 9

Screw and Lockwasher (3 of 6 places)

Registration slot

Figure 8

5.

the fan motor through the canopy ring (make

sure the slot openings of the ring are on top).

then proceed to place the ceiling canopy over

the collar at the top of the motor. Align the

mounting holes with the holes in the motor

and fasten using the screws and lock washers

provided. (Fig. 10).

7. Tighten the mounting screws securely. (Fig.

10)

WARNING

Failure to completely tighten the three screws in step 6 could result in fan loosening and possibly falling.

Collar

Figure 10

Canopy

Canopy ring

Rubber gasket