Hampton Direct Appendix C Appendix C

Appendix C - Router Table Handles

Follow the safety and general instructions for using the KATIE JIG™ System except as

indicated below.

Attaching Router Table Handles to the KATIE JIG™ System

Attach handles to ends of KATIE JIG™ System fixture using screws provided

so that the guide/tuning forks will be down. Securely clamp the boards to

the KATIE JIG® System using 2 clamps. Placement of these clamps should be

done to best accommodate the boards.

CAUTION: Make sure the clamps do not interfere with the router bits.

Prepare Router Table and Set Height of Bits

For best results, use two routers mounted in router table.

Determine height for dovetail bit.

1/2" for guide/tuning forks

Base of router

table

Thickness of pin board

Trim stock or spacer

At least 1/16" of bearing

must extend above base

of router table.

Dovetail bit depth