Masterpage:Right-Full-NoTitle0
EN 51
Filename [HRS7950EU4-EN.fm]
Page 51 April 11, 2002 10:51 am
* The default setting is bold in the table below.
8DIGITAL 3R
ON
OFF
When this function is set to “ON”, the Digital 3R picture system applies edge
correction to the luminance signal to enhance detail.
NOTES:
●Normally it is recommended to keep “DIGITAL 3R” set to “ON”.
●Depending on the type of tape being used, picture quality may be better with
“DIGITAL 3R” set to “OFF”.
●If you use the recorder as the source player for editing, be sure to set “DIGITAL 3R”
to “OFF” before starting.
8POWER SAVE
ON
OFF
When this function is set to “ON”, you can reduce the power consumption
while the recorder is turned off.
NOTES:
●During Power Save mode ...
... the front display panel will be turned off.
... the Just Clock function (墌pg. 60) does not work.
... the picture may be distorted momentarily when you turn on/off the recorder.
●Power Save does not work when ...
... the recorder is in the Timer mode.
... the recorder’s power is turned off after timer-recording or Instant Timer Recording.
... the Automatic Satellite Programme Recording mode is engaged (墌pg. 35).
... “L-2 SELECT” is set to “DECODER” or “SAT” (墌pg.43).
8VIDEO STABILIZER
ON
OFF
When this function is set to “ON”, you can automatically correct vertical
vibration in the picture when playing back unstable recordings made on
another recorder.
NOTES:
●When you finish viewing a tape, be sure to set this function to “OFF”.
●Regardless of the setting, this function has no effect during recording and during
special effects playback.
●The on-screen display may jitter vertically when this function is set to “ON”.
●To watch recordings with close-caption, set this function to “OFF”.
●Video Stabilizer and Digital TBC/NR cannot be used at the same time. If you activate
Digital TBC/NR when “VIDEO STABILIZER” is set to “ON”, Video Stabilizer will be
automatically turned “OFF”.
8S-VHS
ON
OFF
Your recorder can record in S-VHS (Super VHS), S-VHS ET or VHS.
●To record in S-VHS:Set “S-VHS” to “ON”. Then, insert a cassette marked “S-VHS”. The S-VHS
indicator lights up on the front display panel.
The S-VHS recording mode is selected.
●To record in S-VHS ET on a VHS cassette:See “Super VHS ET (S-VHS ET)” on page 26.
●To record in VHS:Insert a cassette marked “VHS”.
Press S-VHS ET on the recorder. You can check the current setting (“S-VHS ET
: ON” or “S-VHS ET : OFF”). If “S-VHS ET : ON” appears on the TV screen,
press S-VHS ET again in about 5 seconds to set it to “OFF”.
The VHS recording mode is automatically selected regardless of the “S-VHS”
mode setting.
●To record in VHS on an S-VHS cassette:Insert a cassette marked “S-VHS”. The S-VHS indicator lights up on the front
display panel. Then, set “S-VHS” to “OFF”. The S-VHS indicator goes off.
The VHS recording mode is selected.
NOTE:
When playing back a tape that has been recorded in S-VHS or S-VHS ET, the S-VHS
indicator lights up on the front display panel regardless of the “S-VHS” mode setting.
HRS7950EU4-EN.fm Page 51 Thursday, April 11, 2002 10:51 AM