IMAGETEAMâ„¢ 2020/5620 System Manual 1 - 13

Using the Scanner with Bluetooth Devices
The IT5620 scanner may be used either with the IT2020-5A base or with other
Bluetooth devices. Scanning the Non-Base Bluetooth Connection bar code
below allows the scanner to be used with other Bluetooth devices (e.g., PDA, PC
- Bluetooth USB Adapter). After you scan the bar code below, follow the
instructions supplied with your Bluetooth device to locate the scanner and
connect to it. If you go out of range with your scanner, the scanner automatically
reconnects to the Bluetooth device. If you want to relink to the IT2020-5A base,
refer to
"Single Scanner Operation"
on page1 -7 or
"Multiple Scanner
Operation"
on page 1-8
.

Changing Bluetooth PIN Code

Some devices require a PIN code as part of the Bluetooth security features. Your
scanner’s default PIN is 1234, which you may need to enter the first time you
connect to your PDA or PC. The PIN code must be numeric and between 1 and
16 characters. To change the PIN, scan the bar code below and then scan the
appropriate numeric bar codes from the Programming Chart inside the back
cover of this manual. Scan Save to save your selection.
Out-of-Range Alarm

Duration

If your scanner is out range of the base, an alarm sounds from both your base
and scanner. To activate the alarm options for the scanner or the base and to
set the alarm duration, scan the appropriate bar code below and then set the
time-out duration (from 0-3000 seconds) by scanning digits on the Programming
Chart inside the back cover, then scanning Save.
Default = 0 sec (no alarm).
Non-Base BT Connection
Bluetooth PIN
Base Alarm Duration
Scanner Alarm Duration