Hangzhou Hechang Trading S3100-SI 3.4 Connecting Optical Fiber

Quick Start
H3C S3100-SI Series Ethernet Switches Chapter 3 Installation
3-13
3.4 Connecting Optical Fiber
Caution:
z After a switch starts, the PON interface may emit invisible radial
when there is no optical connector connected to it and the
protective cap is removed from it. Therefore, do not stare into the
optical interface.
z Be sure to cover the protective cap within 10 seconds if an optical
connector is not in use to keep the optical connector clean.
z Be sure to cover the protective cap if a PON interface has no
optical connector attached.
z Place the protective caps in a safe place when a PON interface has
fiber connected to prepare for the cases the fiber is pulled out.
 Note:
The following section describes the procedures to connect optical fiber
to an ONU card. The procedures also apply to other subcards.
Step 1: Remove the protective cap from the optical connector of
the fiber.
Step 2: Remove the protective cap from the PON interface of the
ONU card.