Install the pop-up drain
Remove the plunger assembly.
Unscrew the drain outlet flange from the tee.
Unscrew the tailpiece from the tee. Wrap the threads with Teflon tape
and replace.
Install the flexible sealing gasket on the flange. Sit it in the sink outlet.
From below, install the black mack gasket, white friction ring, and retainer nut to the flange. Do not tighten the nut against the bottom of the sink at this time.
Thread the tee and tailpiece to the flange. The pivot must face the faucet. If neces- sary, turn the drain assembly.
Tighten the retainer nut.
Sit the plunger assembly in the drain.
Install the horizontal rod through the pivot ball seals and into the tee so that the end goes through the loop in the bottom of the height adjuster. The two pivot ball seals should surround the pivot ball.
Slide the link over end of pull rod. Tighten screw.
Slide one end of spring clip over end of horizontal rod. Slide link over end of hori- zontal rod. Test motion of drain plunger. Reposition link as necessary. There are multiple holes in the link
When satisfied with the action of the drain, slide the other end of the spring clip over the end of the horizontal rod.
English
plunger
flange
sealing gasket | link | |
| ||
mack gasket | spring | |
| clip | |
friction ring |
| |
retainer nut | nut | |
horizontal | ||
| ||
rod |
| |
pivot ball |
| |
pivot | pivot ball | |
tee | seals | |
|
tailpiece
