English
Reset the High Temperature Limit Stop (optional)
Use a 4 mm Allen wrench to push the screw cover into the handle
Use the 4mm Allen wrench to loosen the handle screw 4 complete revolutions. Remove the handle.
Remove the nut cover.
Remove the handle screw from the stem of the cartridge.
Remove the high temperature limit stop.
Replace the high temperature limit stop so that the pin on the cartridge is in the desired slot on the limit stop. Note: the temperatures given in the diagram assume a water heater temperature of 140° F, a cold water temperature of 50° F and a water pressure of 45 PSI.
Replace the nut cover. Replace the handle screw. Use the Allen wrench to turn the screw 4 revolutions.
Replace the handle. Finish tightening the handle screw. Turn on the water and test the faucet.
