English
Insert the cartridge in the rough. The locator tab on the cartridge goes straight into the notch in the rough*.
*Note: The earlier version of the ThermoBalance I rough does not have the notch for the locator tab. See page 6 for cartridge modification instructions.
notch |
positioning |
pin hole |
locator tab |
The positioning pin on the back of the cartridge goes straight into the hole in the rough.
Use the reserved screws to connect the cartridge retainer plate to the rough. Tighten the screws evenly, using a manual screwdriver, in a
the screws.
Perform the following test to check for damage to the ceramic plates inside the stop unit.
Failure to correctly perform this test can result in possible water damage.
Turn on the water supplies. Grasp the stop unit portion of the cartridge and turn it.
If there is a leak around the cartridge, turn the supplies off, and remove the cartridge. Confirm that the sealing gasket from the flushing plug was removed.
Reinstall the cartridge. Turn the stop unit.
If the unit continues to leak, contact Hansgrohe Customer Service for a replacement cartridge.
stop unit |