UNPACKING
When unpacking, check to make sure the following parts are included. Refer to the Assembly Section, and the Assembly Drawing and Parts List at the end of this manual.
If any parts are missing or broken, please call Harbor Freight Tools at the number on the cover of this manual as soon as possible.
OPERATING INSTRUCTIONS
Installing Bits
Caution: Turn router power Off and unplug. Bits are sharp. Handle with care. Check the bit for cracks or damage before using. Use only router bits.
Lock Lever (26)
Collet Nut (20) Loosen to left Tighten to right
Bit
Screw (32) Stopper Pole
Half Nut (18)
Hex Bolt (65)
Stopper (57)
1.Push down on the shaft Lock Lever (26) to keep the shaft stationary. See photo above.
2.Using Wrench (5A), loosen the Collet Nut (20).
3.Insert the bit all the way into the Collet Cone (21).
When using smaller shank bits, insert the Collet Sleeve (2A) into the Collet Cone, then the bit through the Cone.
4.Securely tighten Collet Nut (20).
Do not tighten the Collet Nut without inserting a bit or Collet Cone with bit. Damage can occur.
5.Pull up the Lock Lever (26) to free the shaft.
Cutting Depth Adjustment
1.Place the router on a flat surface.
2.Loosen the Lock Lever (26).
3.Lower router body until the bit just touches the flat surface.
SKU 37793 | For technical questions, please call | Page |
