OPERATING INSTRUCTIONS
Note: For additional information regarding the parts listed in the following pages, refer to the Assembly Diagram at the end of this manual.
1.CAUTION: Always make sure the Power Cord (17) of the Sander is unplugged from its electrical outlet prior to making any adjustments to the tool.
2.Clamp your workpiece down, or insert it in a vise. Make sure the wood you are sanding does not have any nails or metal of any kind in it, or you will ruin the sand- paper and damage the Pad (28).
3.After donning the appropriate safety gear covered on page 2 of this manual, plug in the Sander.
4.Turn on the Sander by turning on the Switch (2).
5.Always run the Sander for a few seconds before contacting the workpiece.
6.Contact the workpiece with minimal pressure. If the Sander is not removing enough material, try a grittier piece of sandpaper. If you want to remove a lot of material fast, use a belt sander.
Note: All orbital sanders leave sanding marks on the workpiece. To minimize sanding marks, always try to sand with the grain of the wood.
7.Occasionally check the sandpaper for tears, wear, or fraying. Replace if neces- sary.
8.When you are finished, turn off the Switch (2).
SKU 42864 | For technical questions, please call | Page 10 |
