EXTENSION CORDS

Note: Performance of this tool may vary depending on variations in local line voltage. Extension cord usage may also affect tool performance.

Your tool has a three-prong plug, therefore you must use a three-prong extension cord. Only use rounded jacket extension cords listed by the Underwriters Laboratories (UL). Improper use of extension cords may cause inefficient operation of your tool which can result in overheating. Be sure your extension cord is rated to allow sufficient current flow to the motor.

If you are using the tool outdoors, use an extension cord rated for outdoor use (signified by “WA” on the jacket).

The extension cord must have a minimum wire size depending on the amperage of the tool and the length of the extension cord. This size is determined by its AWG (American Wire Gauge) rating. The smaller the gauge, the greater the cable’s capacity. The amount of cords used does not matter: Total length determines the minimum AWG rating. Every cord must meet the AWG rating. Use the chart below to determine what AWG rating is required for your situation. Cord length is rated in feet. Harbor Freight Tools can supply UL listed and outdoor rated cords in most AWG ratings as needed.

 

AWG RATING CHART

 

 

 

 

CORD LENGTH

25’

50’

75’

100’

125’

150’

175’

200’

AMPS

AWG

AWG

AWG

AWG

 

AWG

AWG

AWG

AWG

0-10.0

18

18

16

16

 

14

14

12

12

10.1-13.0

16

16

14

14

 

14

12

12

12

13.1-15

14

14

12

12

 

12

12

12

—-

15-18

14

12

12

12

 

12

12

—-

—-

 

 

 

 

 

 

 

 

 

 

GROUNDAGE/VOLTAGE WARNING

Common household current is 110-120 volts. As long as the outlet used with the Power Table Feed is rated from 110-120V there will be no complications using it with household receptacles. Plug the tool into a 110-120V properly grounded outlet protected by a 15-amp, dual element time delay or circuit breaker.

NEVER try to plug a 110-120V tool into a 220-240V circuit or serious complications and possible injury to the operator may occur. The plugs have different shapes to prevent this.

This tool has a three-prong plug. The third (round) prong is the ground. Cutting off the ground will result in a safety hazard and void the warranty.

If the outlet you are planning to use is the two-prong type, do not remove or alter the grounding prong in any manner. Use an adapter and always connect the grounding lug to a known grounding source. It is recommended that you have a qualified electrician replace the two-prong outlet with a properly grounded three- prong outlet.

Page 7 SKU # 42976

Page 7
Image 7
Harbor Freight Tools 42976 Extension Cords, 25’ 50’ 75’ 100’ 125’ 150’ 175’ 200’, 10.0 10.1-13.0 13.1-15 15-18