| Specifications |
|
|
ITEM | DESCRIPTION |
Power Consumption | 120 VAC, 60 Hz, single phase |
|
|
Motor | 4/5 HP |
|
|
Speed Ranges | 0 ~ 1100 low RPM and 0 ~ 2500 high RPM |
|
|
Spindle | |
|
|
Chuck | JT33 Taper; 7/64 to 1/2 inch capacity |
|
|
End Mill Capacity | 1/2 inch |
|
|
Face Mill Capacity | 1 inch |
|
|
Drill Capacity | 1/2 inch |
|
|
Micro Feed Scale | 0.002 inch per line |
|
|
Depth Scale | 0 to 12 inches in 1/16 inch increments |
|
|
Table Slot Width | 1/2 inch |
|
|
Table Size | |
|
|
Unit Height | |
|
|
Weight | 115 lbs. |
|
|
Save This Manual
You will need the manual for the safety warnings and precautions, assembly instructions, operating and maintenance procedures, parts list and diagram. Keep your invoice with this manual. Write the invoice number on the inside of the front cover. Keep the manual and invoice in a safe and dry place for future reference.
Safety Warnings and Precautions
WARNING: When using tool, basic safety precautions should always be followed to reduce the risk of personal injury and damage to equipment.
Read all instructions before using this tool!
1.Keep work area clean. Cluttered areas invite injuries.
2.Observe work area conditions. Do not use machines or power tools in damp or wet locations. Don’t expose to rain. Keep work area well lighted. Do not use electrically powered tools in the presence of flammable gases or liquids.
3.Keep children away. Children must never be allowed in the work area. Do not let them handle machines, tools, or extension cords.
4.Store idle equipment. When not in use, tools must be stored in a dry location to inhibit rust. Always lock up tools and keep out of reach of children.
5.Do not force tool. It will do the job better and more safely at the rate for which it was intended. Do not use inappropriate attachments in an attempt to exceed the tool capacity.
SKU 44991 | Page 2 |
