of the proper size and type to supply the correct current to the tool without heating up. Otherwise, the extension cord could melt and catch fire, or cause electrical damage to the tool. This tool requires use of an extension cord of 0 to 10 amps capability (up to 50 feet), with wire size rated at 18 AWG. Longer extension cords require larger size wire. If you are using the tool outdoors, use an extension cord rated for outdoor use. (signified by “WA” on the jacket).
21.Maintenance. For your safety, service and maintenance should be performed regularly by a qualified technician.
Note: Performance of this tool (if powered by line voltage) may vary depending on varia- tions in local line voltage. Extension cord usage may also affect tool performance.
Warning:The warnings, cautions, and instructions discussed in this instruction manual cannot cover all possible conditions and situations that may occur. It must be under- stood by the operator that common sense and caution are factors which cannot be built into this product, but must be supplied by the operator.
Unpacking
When unpacking, check to make sure the following parts and accessories are included.
|
|
| ITEM | DESCRIPTION |
|
|
| A | Large Wrench |
| A |
|
|
|
|
| B | 13 mm Drill Chuck with Taper Shank | |
| G |
| C | Oil Bottle |
|
| D | Fixing Pin | |
| G |
| ||
|
|
|
| |
|
| E | L - Hex. Wrenches, S: 3, 4, 5, 6 | |
| G |
| ||
|
|
|
| |
|
| F | Socket Head Wrench, D: | |
| F |
| ||
|
|
|
| |
B |
| G | ||
L |
| |||
|
|
| ||
| H | Chuck Key | ||
| D | C | ||
|
|
| ||
| J |
| I | Handle |
|
|
| J | |
|
|
|
|
|
| E | K | K | Fuse, 5A (110 VAC) |
|
| L | Draw Bar | |
| I |
| ||
| H |
|
| |
|
|
| ||
|
|
|
|
If any parts are missing or broken, please call Harbor Freight Tools at the number on the cover of this manual as soon as possible.
Installation
1.Place the machine on a level, flat, and heavy work table or bench; sufficient to support weight and use of product and with sufficient light, and enough side room to allow movement of the Working Table (#19).
2.Secure the machine to the appropriate table or bench using four hex screws (not supplied), by screwing them through the base mounting holes.
SKU 44991 | Page 4 | REV 11/02 |
