Cisco Systems SMNMADPTR manual How to Install, Upgrade, or Downgrade NME-NAM-120S, Summary Steps

How to Install, Upgrade, or Downgrade NME-NAM-120S

How to Install, Upgrade, or Downgrade NME-NAM-120S

This section contains the following information:

•Setting Up Network Module Interfaces, page 7

•Closing a Session, page 11

•Upgrading or Reinstalling NAM Software, page 12

Note	•	If you lose power or connection during any of the following procedures, the system usually detects
		the interruption and tries to recover. If it fails to do so, fully reinstall the system using the boothelper.
	•	You can configure the network module by means of either the CLI or the GUI. This document
		presents CLI configuration instructions. For GUI configuration instructions, see the GUI’s online
		help.

Setting Up Network Module Interfaces

Your first configuration task is to set up network module interfaces to the host router and to its external links. This configuration enables you to access the module to install and configure NME-NAM-120S.

Note The first few steps open the host-router CLI and access the router’s interface to the module. The subsequent steps configure the interface.

SUMMARY STEPS

From the Host-Router CLI

1.enable

2.configure terminal

3.interface integrated-service-engine <slot>/0

4.ip address router-side-ip-address subnet-mask or

ip unnumbered type number

5.[Optional, but if done, do not do Step 6] service-module ip address module-side-ip-addresssubnet-mask

6.[Optional, but if done, do not do Step 5] service-module external ip address external-ip-addresssubnet-mask

7.[Optional] service-module ip default-gateway gateway-ip-address8.end

9.copy running-config startup-config

10.show running-config

Cisco Branch Routers Series Network Analysis Module (NME-NAM-120S) Installation and Configuration Note, 4.0

OL-14942-02 7