Cisco Systems SMNMADPTR Configuration Example, Setup a full 32-bit static route for the, Purpose

Configuring the NME-NAM-120S for Management

	Command or Action	Purpose
Step 9	ip route <NAM-Address> 255.255.255.255 integrated-service-engine	Setup a full 32-bit static route for the
	slot/0	NAM management address.
	(or for the NM-NAM)
	ip route <NAM-Address> 255.255.255.255 analysis-module slot/0
	Example:
	Router(config)# ip route 209.165.200.226 255.255.255.255
	integrated-service-engine 1/0

Step 10 end

Exit the router configuration mode.

Configuration Example

In this configuration example:

•The internal NAM interface is used for management traffic.

•IP addresses from the same routable subnet are assigned to the Integrated-Service-Engine interface and the NAM system

•To conserve IP address space, the Integrated-Service-Engine interface is configured as IP unnumbered to borrow the IP address of the Gigabit Ethernet interface.

•A static route to the NAM through the Integrated-Service-Engine interface is configured.

•The internal NAM interface is used to monitor WAN traffic on interface Serial 0/0, and the external NAM interface is used to monitor LAN traffic on interface Gigabit Ethernet 0/0.

•The NME-NAM-120S is installed in router slot 2.

Figure 2 shows the topology used in the example, and the following sections show the router and NAM configurations:

•Router Configuration (Cisco IOS Software), page 24

•NAM Configuration (NAM Software), page 25

Cisco Branch Routers Series Network Analysis Module (NME-NAM-120S) Installation and Configuration Note, 4.0

OL-14942-02 23