Cisco Systems SMNMADPTR manual Setup the NAM default gateway, Address

Configuring the NME-NAM-120S for Management

	Command or Action		Purpose
Step 11 service-module ip default-gateway <NAM-Default-Gateway-Address>			Setup the NAM default gateway
	(or for the NM-NAM)		address.
	analysis-module ip default-gateway <router-side-address>
	Router (config-if)#	service-module ip default-gateway
209.165.201.222
	(or for the NM-NAM)
	Router (config-if)#	analysis-module ip default-gateway
209.165.201.222

Step 12 end

Exit the router configuration mode.

Configuration Example

In this configuration example:

•The external NAM interface is used for management traffic.

•The Integrated-Service-Engine interface is configured as IP unnumbered to borrow the IP address of the loopback interface.

•The borrowed loopback interface IP address is not routable.

•The NAM system is configured with an IP address from the LAN subnet that is connected to the external NAM interface.

•The internal NAM interface is used to monitor WAN traffic on interface Serial 0/0, and the external NAM interface is used to monitor LAN traffic on interface Fast Ethernet 0/0.

•The NME-NAM-120S is installed in router slot 3.

Figure 4 shows the topology used in the example, and the following sections show the router and NAM configurations:

•Router Configuration (Cisco IOS Software), page 32

•NAM Configuration (NAM software), page 32

Cisco Branch Routers Series Network Analysis Module (NME-NAM-120S) Installation and Configuration Note, 4.0

30 OL-14942-02