Cisco Systems SMNMADPTR manual Opening a Session, You can conduct only one session at a time

How to Install, Upgrade, or Downgrade NME-NAM-120S

Opening a Session

This section describes how to open a session on the network module.

Note	•	Before you install your application software, opening a session brings up the bootloader. After you
		install the software, opening a session brings up the application.
	•	You can conduct only one session at a time.

SUMMARY STEPS

From the Router CLI

1.enable

2.service-module integrated-service-engine slot/0 session clear

3.service-module integrated-service-engine slot/0 session

DETAILED STEPS

	Command or Action	Purpose
Step 1
	enable	Enters privileged EXEC mode on the
		host router. Enter your password if
	Example:	prompted.
	Router> enable
Step 2
	service-module integrated-service-engine slot/0 session clear	Make sure there is not an existing
		session which will prevent this
	Example:	session to login successfully.
	Router# service-module integrated-Service-Engine 1/0 session clear
	[confirm]
	[OK]
	Router#
Step 3
	service-module integrated-service-engine slot/0 session	Begins a session on the specified
		module.
	Example:
	Router# service-module integrated-Service-Engine 1/0 session
	Trying 172.20.98.151, 2066 ... Open
	Cisco Network Analysis Module (NME-NAM-120S)
	NAM.domain.name login:

Cisco Branch Routers Series Network Analysis Module (NME-NAM-120S) Installation and Configuration Note, 4.0

10 OL-14942-02