Cisco Systems SMNMADPTR manual Configuring the NME-NAM-120S for Management, From the Router Prompt

Configuring the NME-NAM-120S for Management

	Command or Action		Purpose
Step 9
	Select 4, and follow the prompt to enter a FTP URL		Download helper image from FTP server
	Main menu		and write to NAM flash.
	1	- Download application image and write to HDD
	2	- Download application image and reformat HDD
	3	- Download bootloader and write to flash
	4	- Download helper and write to Compact Flash
	5	- Display software versions
	6	- Reset application image CLI passwords to default
	7	- Change file transfer method (currently ftp/http)
	8	- Show upgrade log
	9	- Send Ping
	f - Format the Flash
	r - Exit and reset Services Engine
	h - Exit and shutdown Services Engine
	Selection [123456789frh]: 4
Step 10
	Select r and confirm to reboot the NAM		Reboot the NAM. By default the NAM will
			boot to the NAM application image.
Step 11
	Follow the steps described in Closing a Session, page 11 to		Close the NAM console session.
	close the NAM console session.

Configuring the NME-NAM-120S for Management

NME-NAM-120S has an internal Gigabit Ethernet interface and an external interface. You can use either interface for NAM management traffic such as the NAM web GUI, telnet or ssh, but not both. You can configure the NAM internal interface to use either IP unnumbered or a routable subnet.

See the following sections for information about how to configure the NME-NAM-120S internal interfaces for management:

•Configuring the Internal Interface for Management—IP Unnumbered, page 21

•Configuring the Internal Interface for Management—Routable Subnet, page 25

•Configuring the External Interface for Management, page 28

Configuring the Internal Interface for Management—IP Unnumbered

This section describes how to configure the NME-NAM-120S internal interface for IP unnumbered.

Note The addresses used for the interface address (Step 4), the NAM-Address (Steps 6 and 9), and the NAM-Default-Gateway-Address (Step 7) must all be in the same subnet.

SUMMARY STEPS

From the Router Prompt

1.enable

2.configure terminal

3.interface integrated-service-engine slot/0

Cisco Branch Routers Series Network Analysis Module (NME-NAM-120S) Installation and Configuration Note, 4.0

OL-14942-02 21