Cisco Systems SMNMADPTR manual Enter IOS exec mode, Enter IOS configuration from terminal, router

Configuring the NME-NAM-120S for Management

DETAILED STEPS

	Command or Action		Purpose
Step 1
	enable		Enter IOS exec mode.
Step 2
	configure terminal		Enter IOS configuration from terminal
			mode.
Step 3
	interface loopback <loopback-number>		Create a loopback interface 0 on the
	Router (config)# interface loopback 0		router.
	Router (config-if)#
Step 4
	ip address <bogus-address> <subnetmask>		Set a bogus address on the loopback
			interface. In the example, interface
	Example:		loopback0 is assigned with an address
	Router(config-if)#ip address 10.1.1.1 255.255.255.0		10.1.1.1/24.
Step 5
	no shutdown		Enable the loopback interface.
Step 6
	exit		Exit from interface configuration mode
			to the global configuration mode.
	Example:
	Router(config-if)# exit
	Router(config)#
Step 7
	interface integrated-service-engine slot/0		Enter the IOS interface configuration
	(or for the NM-NAM)		mode for the integrated-service-engine
			interface.
	interface analysis-module slot/0
Step 8
	ip unnumber loopback <number>		Borrow the address that was set to the
			loopback interface in Step 4.
	Example:
	Router (config-if)#ip unnumbered loopback 0
Step 9
	no shutdown		Bring up the integrated-service-engine
			interface.
Step 10
	service-module external ip address <NAM-Address> <subnetmask>		Set <NAM-Address> to the NAM
	(or for the NM-NAM)		External interface.
	analysis-module ip address <NAM-Address> <subnetmask>
	Example:
	Router (config-if)#service-module external ip address
	209.165.201.2	255.255.255.224

Cisco Branch Routers Series Network Analysis Module (NME-NAM-120S) Installation and Configuration Note, 4.0

OL-14942-02 29