Cisco Systems SMNMADPTR Closing a Session, Control-Shift-6, From the Router prompt, disconnect

How to Install, Upgrade, or Downgrade NME-NAM-120S

Closing a Session

This section describes how to close a session on the network module.

Note	• Before you install your application software, opening a session brings up the bootloader. After you
		install the software, opening a session brings up the application.
	•	You can conduct only one session at a time.
	•	In NAM 4.0, the CLI command exit automatically closes a session.

SUMMARY STEPS

Use the following steps to close a session:

From the NAM CLI, NAM login, NAM helper, or NAM bootloader prompts

1.Control-Shift-6 x

From the Router prompt

2. disconnect <or>

service-module integrated-service-engine slot/0 session clear

DETAILED STEPS

Command or Action Purpose

From the NAM CLI, NAM login, NAM helper, or NAM bootloader prompts

Step 1 Press Control-Shift-6 x.

Note This key sequence returns you to the router prompt.

Closes the service-module session and returns to the router CLI.

Note The service-module session stays up until you clear it in the next step. While it remains up, you can return to it from the router CLI by pressing Enter.

From the Router CLI

Step 2 disconnect

or

service-module integrated-service-engine slot/0 session clear

Example:

Router# service-module integrated-Service-Engine 1/0 session clear [confirm]

[OK]

Router#

Disconnects the session connection or clears the service module session for the specified module.

When prompted to confirm this command, press Enter.

Cisco Branch Routers Series Network Analysis Module (NME-NAM-120S) Installation and Configuration Note, 4.0

OL-14942-02 11