Mark Levinson N 320S owner manual Display Intensity, To set the sleep timer

Controls & Modes

SLEEP –OFF–

4-2

Mark Levinson

SLEEP (continued)

When the –OFF– setting is selected, the Nº 320S does not automatically enter standby. When a time increment setting is selected, the Nº 320S automatically enters standby after the designated amount of time has passed. For example, if the 2h 30m setting is selected, the Nº 320S automatically enters standby after 2 hours and 30 minutes have passed.

To set the sleep timer:

1.Follow the instructions on the previous page to take the Nº 320S out of standby.

2.Press and hold the front panel or remote control standby button until the SLEEP parameter opens on the front panel display as shown to the left.

3.Press and release the standby button to cycle through all available SLEEP parameter settings.

4.When the desired setting is selected, press the front panel or remote control enter button to close the SLEEP parameter.

•Otherwise, the SLEEP parameter automatically closes a few seconds after the last command is received. If this occurs, the selected setting is automatically applied.

Note

The SLEEP parameter is set to –OFF– whenever the Nº 320S is placed into standby.

Display Intensity

Controls the illumination of front panel display characters and the front panel standby LED. Four illumination levels are available, including FULL (100%), HALF (50%), DIM (25%), and OFF (0%). The factory-default illumination level is FULL (100%).

When the OFF (0%) illumination level is selected:

•The front panel display automatically activates whenever a change in status is detected.

•The front panel standby LED lights at the FULL (100%) illumination level.