Getting Started | Mark Levinson |
Remote Control
Batteries
Screws |
Placement (continued)
•DO NOT install the Nº 320S near unshielded TV or FM antennas, cable TV decoders, and other
•DO NOT place the Nº 320S on a windowsill or in another location in which it will be exposed to direct sunlight.
•DO NOT obstruct the IR receiver located in the front panel display. When the Nº 320S is not using the ir input connector, the remote control IR transmitter must be in
CAUTION
BEFORE MOVING THE Nº 320S, MAKE SURE IT IS POWERED OFF WITH THE FRONT PANEL POWER BUTTON. THEN, MAKE SURE THE POWER CORD IS DISCONNECTED FROM THE ~ac mains CONNECTOR AND THE ELECTRICAL OUTLET.
WARNING
MAKE SURE ALL COMPONENTS ARE PROPERLY GROUNDED. DO NOT DEFEAT THE SAFETY PURPOSE OF POLARIZED OR
The remote control comes with two AAA batteries, which should be replaced as needed. It is recommended to use Alkaline batteries, which do not leak and last longer.
To replace the remote control batteries:
1.Locate the battery compartment cover on the back of the remote control.
2.Use the supplied
3.Remove the battery compartment cover from the remote control.
4.Remove the old batteries inserted in the battery compartment (if applicable).