Nº 320S | Controls & Modes |
L – R Phono Alignment Tip
MODE: L + R
MODE: L – R
8.When the desired adjustments have been made, press and release the balance button to close the balance control.
•Otherwise, the balance control automatically closes a few seconds after the last command is received. If this occurs, the selected setting is automatically applied.
9.Press and release the mono button to cancel L + R mono playback and return to stereo playback.
L – R mono playback simplifies the process of aligning phono cartridge azimuth.
To use L – R mono playback to align phono cartridge azimuth:
1.Press and hold the remote control mono button until the MODE parameter opens on the front panel display as shown to the left.
2.Press and release the mono button to cycle through all available MODE parameter settings until the L – R mono mode is selected as shown to the left.
3.Press and release the front panel or remote control enter button to close the MODE parameter.
•Otherwise, the MODE parameter automatically closes a few seconds after the last command is received. If this occurs, the selected setting remains selected.
4.When the MODE parameter is closed, press and release the remote control mono button to activate L – R mono playback.
5.Begin playback of the desired mono recording.
6.Using the L – R output signal, adjust the associated phono cartridge azimuth to achieve minimal output signal.
•Playing a mono recording when L – R mono playback is activated should result in silence (no output signal). Because phono cartridges differ, it is recommended to adjust azimuth to achieve minimal output signal.
7.Press and release the mono button to cancel L – R mono playback and return to stereo playback.
