Nº 320S | Controls & Modes |
To activate and use SSP mode:
1.Make sure the Nº 320S and all associated components are powered off and disconnected from electrical outlets.
2.Connect the output connectors on the surround sound source component to the input connectors on the surround sound processor.
•For example, if this source component is a DVD player, connect the output connectors on the DVD player to the input connectors on the processor.
3.Connect the center, surround, and subwoofer output connectors on the processor to the appropriate input connectors on the power amplifier(s).
4.Connect the front left and right output connectors on the processor to the desired stereo input connectors on the Nº 320S.
•For best performance, use balanced (XLR) connections whenever possible.
5. Connect the main output connectors on the Nº 320S to the | |
appropriate input connectors on the power amplifier(s). |
|
•A balanced (XLR) connection between the Nº 320S and the associated power amplifier will offer the highest possible performance with the best protection against RF interference and other common mode noise.
CAUTION
BEFORE ACTIVATING SSP MODE, SET THE ASSOCIATED
SURROUND SOUND PROCESSOR VOLUME CONTROL TO
A REASONABLE LEVEL TO PREVENT SENDING
DANGEROUS SIGNAL LEVELS TO THE LOUDSPEAKERS.
6.Using the Nº 320S, rotate the front panel select knob or press the remote control select ± buttons to select the input for which the stereo input connector selected in step 3 is assigned.
•The front panel display indicates the name and volume level of the selected input.
(continued)