Nº 320S | Basic Operation |
Operation Considerations
Note
The Nº 31, Nº 31.5, Nº 37, and Nº 39 remote controls can be used to control Nº 320S master volume level. This command is available over IR (not Link connections). Before using one of these remote controls to adjust Nº320S master volume level, make sure the digital transport setup menu volume control parameter is set to fixed.
Remote Control Overview
The Nº 320S remote control provides full operation of the Nº 320S. Unless otherwise specified, the numbered items in the Command Overview section (next page) indicate the commands the remote control performs during normal operating mode. Refer to Section
3:Setup Menu and Section 4: Controls & Modes for information about other commands the remote control performs.
The remote control requires special consideration during operation to ensure optimal performance. Pay particular attention to the bulleted items below and to other precautions that appear
throughout this user guide. The bulleted items that begin below
input connector.
•DO eliminate obstructions between the remote control IR transmitter and the front panel display IR receiver.
•DO position the remote control within ±45˚ of a line that is perpendicular to the front panel display IR receiver. At more severe angles, attempt to “bounce” the remote control signal off a wall or another surface so the signal is received at the IR receiver at a reasonable angle.
•DO position the remote control within 17 feet (5m) of the front panel display IR receiver. If the Nº 320S is placed inside a glass cabinet, tinted glass will reduce the remote control range.
•DO replace the remote control batteries as needed. Refer to Remote Control Batteries (page
•DO NOT obstruct the front panel display IR receiver.
•DO NOT expose the front panel display IR receiver to strong sunlight, halogen light, or fluorescent light. This can cause IR reception to become unreliable.
(continued)