Cisco Systems Comprehensive Guide for SMNMADPTR Router Installation and Upgrade

How to Install, Upgrade, or Downgrade NME-NAM-120S

Upgrading the NAM Helper Image

This section describes how to upgrade the NAM helper image.

SUMMARY STEPS

1.Download the NAM helper image from CCO and store it on an FTP server.

From the Router Enable (exec) Mode Prompt

2.service-module integrated-service-engine slot/0 reload

3.service-module integrated-service-engine slot/0 session

Note This will open a connection to the NAM console.

From the Service Module Interface

While the service module reboots, it displays the following prompt:

Enter *** to change boot configuration:

4.Enter ***.

After you enter *** in Step 4 above, you will be at the bootloader prompt. From this prompt, you can either boot the NAM helper located at a TFTP server or boot the pre-installed helper image in the NAM flash.

–To boot the NAM helper image that is located at a TFTP server, do Steps 5, 6, and 7. Skip Step 8.

–To boot the pre-installed helper image on the NAM compact flash, skip Steps 5, 6 and 7, then do Steps 8-11.

5.configure

6.show config

7.boot helper

8.boot compactflash

Note For NM-NAM, enter boot flash.

9.Select 4, and follow the prompts.

10.Select r, and confirm the reboot the NAM.

11.Close the NAM console connection as described in Closing a Session, page 11.

Cisco Branch Routers Series Network Analysis Module (NME-NAM-120S) Installation and Configuration Note, 4.0

OL-14942-02 19