Configuring the
4.ip unnumber <interface> <number>
5.no shutdown
6.
7.
8.exit
9.ip route
10.end
DETAILED STEPS
| Command or Action | Purpose |
Step 1 |
|
|
enable | Enter IOS exec mode. | |
Step 2 |
|
|
configure terminal | Enter IOS configuration from terminal | |
|
| mode. |
Step 3 |
|
|
interface | Enter IOS interface configuration mode | |
|
| for the |
|
| interface. |
Step 4 |
|
|
ip unnumber <interface> <number> | Borrow the address that was set at | |
|
| <interface>. In the example, interface |
| Example: |
|
| the address set in gigabitethernet0/1 | |
| Router | |
| interface. | |
|
| |
Step 5 |
|
|
no shutdown | Enable the | |
|
| interface. |
Step 6 |
|
|
Set | ||
| Router | Internal interface. |
|
| |
| 255.255.255.224 |
|
Step 7 |
|
|
Setup the NAM default gateway | ||
|
| address. |
| Example: |
|
| Router |
|
| 209.165.200.225 |
|
Step 8 |
|
|
exit | Exit from the router interface | |
|
| configuration mode to the router global |
|
| configuration mode. |
|
|
|
Cisco Branch Routers Series Network Analysis Module
22 |
| |
|
