
Configuring the
| Command or Action | Purpose | ||
Step 3 | interface | Enter the IOS interface configuration mode | ||
| Or for | for the | ||
|
|
| ||
| interface |
|
| |
Step 4 |
|
| ||
ip address | Set a routable address to the | |||
|
|
|
| |
| Example: |
|
|
|
| Router |
|
| |
| 255.255.255.224 |
|
|
|
Step 5 |
|
|
| |
no shutdown |
| Bring up the | ||
|
|
| interface. | |
Step 6 |
|
| ||
Set | ||||
| (or for the | interface. | ||
| Note | The | ||
|
|
| ||
| Example: |
|
| same subnet as |
|
|
|
| |
| Router |
|
| |
| 255.255.255.224 |
|
|
|
| (or for the |
|
| |
| Router |
|
| |
| 209.165.200.226 | 255.255.255.224 |
|
|
Step 7 |
|
| ||
Setup NAM default gateway address to be | ||||
|
|
| the | |
| Example: |
| address, which is | |
|
|
|
| |
| Router |
|
| |
| 209.165.200.225 |
|
|
|
Step 8 | end |
Exit the router configuration mode.
Configuration Example
In this configuration example:
•The internal NAM interface is used for management traffic.
•IP addresses from the same routable subnet are assigned to the
•A static route to the NAM through the
•The internal NAM interface is used to monitor WAN traffic on interface Serial 0/0, and the external NAM interface is used to monitor LAN traffic on interface Fast Ethernet 0/0.
•The
Figure 3 shows the topology used in the example, and the following sections show the router and NAM configurations:
•Router Configuration (Cisco IOS Software), page 27
•NAM Configuration (NAM Software), page 28
Cisco Branch Routers Series Network Analysis Module
26 |
| |
|