Operation (continued)
2.Make sure the lever on the Flex Hose Base (#7) is off (perpendicular to the hose). Fill the Tank (#1) with coolant through the Filter (#6).
3.If your worktable has a groove around it to recycle the coolant, run the hose (not provided) from the table into the Filter (#6).
4.Turn the lever on the Flex Hose Base (#7) parallel to the hose and plug in the pump to begin flow. Caution: Recycled coolant will become very hot; contact with hot coolant could result in personal injury.
Maintenance
Make sure the pump is not plugged in when servicing the unit.
1.When the coolant tank is empty, remove the Pump Base (#12) and clean off any
2.Periodically remove the Filter (#6) and clean it; remove any trapped metal filings.
3.Occasionally disconnect the Flex Hose Base (#7) and check for
residue. Clean if necessary.
Part No. | Description | Qty. |
1 | Tank | 1 |
2 | Cover | 1 |
3 | Pump | 1 |
4 | Pan Screw | 3 |
5 | Hex Nut | 3 |
6 | Filter | 1 |
7 | Flex Hose Base | 1 |
8 | Hose | 1 |
9 | Snap Ring | 2 |
10 | Adaptor | 1 |
11 | Hose Clamp | 2 |
12 | Pump Base | 1 |
PLEASE READ THE FOLLOWING CAREFULLY
THE MANUFACTURER AND/OR DISTRIBUTOR HAS PROVIDED THE PARTS DIAGRAM IN THIS MANUAL AS A REFERENCE TOOL ONLY. NEITHER THE MANUFACTURER NOR DISTRIBUTOR MAKES ANY REPRESENTATION OR WARRANTY OF ANY KIND TO THE BUYER THAT HE OR SHE IS QUALIFIED TO MAKE ANY REPAIRS TO THE PRODUCT OR THAT HE OR SHE IS QUALIFIED TO REPLACE ANY PARTS OF THE PRODUCT. IN FACT, THE MANUFACTURER AND/OR DISTRIBUTOR EXPRESSLY STATES THat ALL REPAIRS AND PARTS REPLACEMENTS SHOULD BE UNDERTAKEN BY CERTIFIED AND LICENSED TECHNICIANS AND NOT BY THE BUYER. THE BUYER ASSUMES ALL RISK AND LIABILITY ARISING OUT OF HIS OR HER REPAIRS TO THE ORIGINAL PRODUCT OR REPLACEMENT PARTS THERETO, OR ARISING OUT OF HIS OR HER INSTALLATION OF REPLACEMENT PARTS THERETO.
NOTE: Some parts are listed and shown for illustration purposes only and are not available individually as replacement parts.
SKU 45333 | Page 5 |
