Note: Performance of this tool (if powered by line voltage) may vary depending on variations in local line voltage. Extension cord usage may also affect tool perfor- mance.

Warning: The warnings, cautions, and instructions discussed in this instruc- tion manual cannot cover all possible conditions and situations that may oc- cur. It must be understood by the operator that common sense and caution are factors which cannot be built into this product, but must be supplied by the operator.

Unpacking

When unpacking, check to make sure parts listed on page 5 are included. If any parts are missing or broken, please call Harbor Freight Tools at the number on the cover of this manual.

Assembly

Refer to the Assembly Drawing on page 6.

1.Unsnap both of the Snap Rings (#9) and remove the Cover (#2).

2.Insert the Pump (#3) through the hole in the Cover (#2) making sure the gasket is centered on the brim of the Pump (#3) and snug between the

Pump (#3) and the top of the Cover (#2). Put the matching metal brim (provided) on the bottom of the Pump (#3) and snug it up to the bottom of the Cover (#2). Line up the holes of the brim of the Pump (#3), the Cover (#2), the gasket, and provided metal brim. Secure through the top with 3 Pan Screws (#4) and Hex Nuts (#5).

3.Connect the Hose (#8) to the Adaptor (#10) by slipping a Hose Clamp (#11) over the Hose (#8) and then slide the Hose (#8) onto the barbed end of the Adaptor (#10). Tighten with Hose Clamp (#11).

4.Attach the Adaptor (#10) to the Pump Base (#12) by sliding it on (pressure fit).

5.Before snapping on the Cover (#2), insert the other end of the hose through the smallest hole on the cover and secure it to the barbed end of the Flex

Hose Base (#7) with a Hose Clamp (#11).

6.Snap the entire Cover (#2) unit back onto the Tank (#1). Set the

Filter (#6) into the remaining hole on the Cover (#2).

Warning! Position the electrical cord and plug so that it is not in contact with coolant or wet surfaces.

Operation

1.Make sure the magnetic Flex Hose Base (#7) is near your workpiece and the magnetic base is secure to the metal table you are working on. The tip of the Hose (#8) on the Flex Hose Base (#7) should be almost contacting the workpiece.

SKU 45333

Page 4

REV 09/03

Page 4
Image 4
Harbor Freight Tools 45333 Unpacking, Assembly, Operation, Hose Base #7 with a Hose Clamp #11, REV 09/03