Harbor Freight Tools 47003 Assembly and Operating Instructions, Assembly Diagram on

20. WARNING! People with pacemakers should consult their physician(s) before using this product. Operation of electrical equipment in close proximity to a heart pacemaker could cause interference or failure of the pacemaker.

21. WARNING! The warnings, precautions, and instructions discussed in this manual cannot cover all possible conditions and situations that may occur. The operator must understand that common sense and caution are factors which cannot be built into this product, but must be supplied by the operator.

ASSEMBLY AND OPERATING INSTRUCTIONS

NOTE: For additional references to the parts listed in the following pages, refer to the

Assembly Diagram on page 18.

To Remove Or Install A Cut-Off Wheel:

1. WARNING! Prior to performing any assembly procedures, make sure the Power Cord (65) of the Cut-Off Saw is unplugged from its electrical outlet. Also, make sure the Cut-Off Wheel has completely cooled and wear work gloves while replacing the Wheel.

2.Place the Cut-Off Saw in its fully raised position. To do so, turn the Swing Lock Handle (81) clockwise while pushing down on the Handle (66, 71).

(See Figure D, next page.)

SKU 47003 PAGE 10