Harbor Freight Tools 47003 operating instructions See Figures D, and J

2.If necessary, adjust the angle of cut. Then, secure the workpiece in the Quick Lock Vise. (See Figure I.)

3.Plug the Power Cord (65) into the nearest 120 volt, grounded, electrical outlet. Depress the Safety Button (80) with your thumb, and squeeze the Power Switch (74) on the Handle (66, 71). Then, release the Safety Button. (See Figure J.)

SAFETY BUTTON				POWER SWITCH
(80)
			(74)
CARBON BRUSH CAP			CARBON BRUSH CAP
			(28)
(28)
					CARBON BRUSH
CARBON BRUSH
		CARBON BRUSH CAP	(29)
(29)
	(28)				BRUSH HOLDER
BRUSH HOLDER
		CARBON BRUSH	(30)
(30)
	(29)
		BRUSH HOLDER			CUT-OFF WHEEL
	(30)		(57)
POWER CORD					FIGURE J
(65)

4.Allow the Cut-Off Wheel (57) to spin up to full speed. Then, slowly lower the Cut- Off Wheel (57) into the workpiece.

(See Figures D, and J.)

5.If the Cut-Off Wheel (57) does not pass completely through the workpiece, Raise

the Saw Arm, turn off and unplug the Saw, and wait until it comes to a complete stop. Remove stock being cut. Then, lower the Cut-Off Wheel, following the instructions on page 13. (See Figure I.)

6.After adjusting the Screw (44), press down on the Cut-Off Saw and make sure the Cut-Off Wheel (57) does not contact the bottom of the Saw Base (2) or any other part of the Saw Base. (See Figure I.)

7.If the Cut-Off Wheel (57) touches the Saw Base (2) or any other part of the Saw Base, raise the Cut-Off Wheel until it clears, following the instructions on page 13.

(See Figure I.)

8.Plug the Cut-Off Saw back into its electrical outlet, and finish making the cut following Steps #3 and #4 above.

SKU 47003 PAGE 14