8.BEFORE DRILLING OR CUTTING, TURN ON THE MICRO MILL/DRILL MACHINE AND CHECK FOR BIT WOBBLE OR MACHINE VIBRATION. If this is found, turn off the tool and correct the problem before using.
9.SECURE THE WORKPIECE. Whenever possible, secure the workpiece to the Worktable (part #105) with a vise or clamps. If the workpiece begins to spin, do not attempt to stop it with your hands. Turn the Micro Mill/Drill Machine OFF, and wait until the workpiece stops spinning before attempting to remove it.
(See Figure B, and Assy. Diagram.)
10.ALWAYS FEED THE WORKPIECE INTO AND AGAINST THE ROTATIONAL DIRECTION OF A BIT OR CUTTER.
11.WHEN DRILLING OR CUTTING SOFTER MATERIALS OR SMALL HOLES, USE THE HIGHER SPEEDS. WHEN DRILLING OR CUTTING HARDER MATERIALS OR LARGER HOLES, USE THE SLOWER SPEEDS.
12.NEVER LEAVE THE MICRO MILL/DRILL MACHINE UNATTENDED WHEN IT IS RUNNING. Turn off the tool, and wait until it has completely stopped before leaving.
13.ALWAYS UNPLUG THE MICRO MILL/DRILL MACHINE FROM ITS ELECTRICAL SUPPLY SOURCE BEFORE PERFORMING ANY INSPECTION, MAINTENANCE, OR CLEANING PROCEDURES.
14.WARNING: Some dust created by power sanding, sawing, grinding, drilling, and other construction activities, contain chemicals known (to the State of California) to cause cancer, birth defects or other reproductive harm. Some examples of these chemicals are: lead from
15.WARNING: People with pacemakers should consult their physician(s) before using this product. Operation of electrical equipment in close proximity to a heart pacemaker could cause interference or failure of the pacemaker.
SKU 47158 | For technical questions, please call | Page |
