22.Never leave the Bandsaw unattended while it is running. Do not put the Bandsaw down until the blade comes to a complete stop.
23.Cutting Material. Make sure cutting material is securely fastened down before operating the Bandsaw. Work slowly and carefully when cutting corners, sharp edges, ragged welds, etc., to avoid snagging.
Caution: Cutting material and the motor housing can get very hot during operation. Stop work until unit cools down to safe temperature.
Spray on a coolant or water onto the blade.
Note: Performance of this tool (if powered by line voltage) may vary depending on varia- tions in local line voltage. Extension cord usage may also affect tool performance.
Warning:The warnings, cautions, and instructions discussed in this instruction manual cannot cover all possible conditions and situations that may occur. It must be understood by the operator that common sense and caution are factors which cannot be built into this product, but must be supplied by the operator.
Unpacking
When unpacking, check to make sure all of the parts on the Parts List on Page 9 of this manual are included. If any parts are missing or broken, please call Harbor Freight Tools at the number on the cover of this manual as soon as possible.
Assembly
1.WARNING! Always make sure that the unit is off and unplugged before as- sembly.
2.The Guide Bar needs (63) to be assembled to the bandsaw for proper operation.
3.Remove the Screws (62) on the Frame (21), along with their Spring and Flat Washers (47, 46).
4.Install the Guide Bar around the blade as shown using the Screws (62), Spring Washers (47), and Flat Washers (46).
46, 47, & 62
63
REV 06/06
SKU 47840 | For technical questions, please call | Page |
