SAFETY
Operating Instructions
Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the beginning of this manual including all text under subheadings therein before set up or use of this product.
Tool Set Up
TO PREVENT SERIOUS INJURY FROM ACCIDENTAL OPERATION:
Turn the Power Switch of the tool off and unplug the tool from its electrical outlet before performing any procedure in this section.
TO PREVENT SERIOUS INJURY:
DO NOT OPERATE WITH ANY GUARD DISABLED, DAMAGED, OR REMOVED. Moving guards must move freely and close instantly.
Table Adjustment
SETUP
OPERATION
1.Adjust the Table (54) by loosening the Pivot Lever (51), moving the Table, and tightening the Pivot Lever.
2.Tilt the Table by loosening the Angle Bolt (56) and tilting to the required angle.
The angle can be read using the Angle Scale (53).
3.TO ENSURE THAT THE DRILL IS ENTIRELY PERPENDICULAR TO THE TABLE,
insert a straight round bar (not included) in the Chuck (72), place a square on the Table (54) and bring it up to the round bar. Adjust the angle as needed.
CAUTION! To prevent injury from unexpected Table movement, tighten Angle Bolt (56) and Pivot Lever (51) after adjustment.
Table | Column (8) |
Support (52) |
|
Angle Bolt (56) | Pivot |
Lever (51) | |
under Table |
|
Figure D: Table Adjustment
MAINTENANCE
Setting a Drilling Depth
Located around the Spindle Feed Shaft is a Depth Stop Collar (A) with a scale. The collar is capable of turning about the shaft, and may be locked in place by a Locking Screw (B).
1. | Lower the drill (with the power OFF) so that it |
|
| contacts the material and hold in that position. |
|
2. | Loosen the locking screw and turn the collar |
|
| so that the measurement for the depth of the |
|
| hole required is in line with the pointer (C). | Figure E: Drill Depth Adjustment |
3. | Lock the collar in this position using the locking screw. |
|
Page 8 | For technical questions, please call | Item 60238 |
