Rail Assembly must always be se- cured in the horizontal position for travel. Cover the air inlet hole on the Oil Plug (37) before transport. See FIGURE 3.
15.Pull up and down on the Hitch Cou- pler to make sure the hitch ball is fitting snugly in the Hitch Coupler.
There should be no play between the hitch ball and Hitch Coupler. If there is play, tighten the Adjustment Nut until no play is present. If the Adjust- ment Nut is too tight, the Handle will not lock.
Note: The hitch will accept a 2 inch hitch ball.
Operating Instructions
Read the entire Important Safety Information section at the beginning of this manual including all text under subheadings therein before set up or use of this product.
Engine Operation
Inspect engine and equipment looking for damaged, loose, and missing parts before set up and starting. If any problems are found, do not use equipment until fixed properly.
Start Procedure
Before starting the engine: a. Follow the Set Up Instruc-
tions to prepare the equip- ment. Follow all instructions in the separate engine manu- al provided with the engine.
b. Inspect the equipment and engine.
c. Fill the engine with the prop-
er amount and type of fuel and oil.
d. Read the Equipment Opera- tion section that follows.
1.Start and operate the engine accord- ing to the provided engine manual.
Equipment Operation
1.Start and operate the engine accord- ing to the provided engine manual.
2.Block the wheels before changing the position (vertical/horizontal) of the unit.
FIGURE 4
Vertical Position
Place
Log
Here
Base
3.In FIGURE 1, the Rail Assembly (2) is shown in Horizontal mode for opera- tion and travel. In FIGURE 4 the unit is shown in the vertical position. To change positions, remove the Hair Pin Clip (29) and the Push Pin (26). A
SKU 65076 | For technical questions, please call | Page 10 |
