Hair Pin Clip into the vertical position hole (See FIGURE 1). Reverse the process to return to the horizontal position.
4.Remove the Oil Plug (37) and fill the tank with Hydraulic oil (not included). To check the oil level remove the Dipstick (62), check the level then replace it. The oil should be at the upper notch of the Dipstick. Be sure that a constant hydraulic oil level of 2.5 gallons is maintained.
5.The hydraulic system must be vented during operation or it may become vacuum locked and stop working properly. To vent the system, open the air inlet hole (See FIGURE 3) by loosening the Oil Plug. You may have to move the
6.The maximum length of each log can not exceed 25 inches or a diameter of 8 inches.
7.Place the log on the Splitter Base as shown in FIGURES 1 and 4. Make sure the wedge on the Slide Assem- bly is facing the log. (See FIGURE 1).
8.Grip the Directional Valve (58) and move it into the lower position to split the log.
9.To back the wedge off the log, move the Directional Valve away from the log just split.
10.Once the log is split, remove the piec- es. Continue, as explained above, until all logs are split.
11.To prevent accidents, turn off the engine and disconnect its spark plug wire after use. Wait for the engine to cool, clean external parts with clean cloth, then store the equipment out of children’s reach according to the Storage instructions in this manual.
SKU 65076 | For technical questions, please call | Page 11 |
