User Maintenance
Instructions
Procedures not specifically explained in this manual must be performed only by a qualified technician.
To prevent serious injury from
accidental operation: Turn off the tool, detach the air supply, safely discharge any residual air pressure in the tool, and release the throttle and/or turn the trigger to its off position before performing any inspection, maintenance, or cleaning procedures.
To prevent serious injury from tool failure:
Do not use damaged equipment. If abnormal noise, vibration, or leaking air occurs, have the problem corrected before further use.
Cleaning, Maintenance,
and Lubrication
Note: These procedures are in addition to the regular checks and maintenance explained as part of the regular op- eration of the
Cleaning the Sprayer
1.IMPORTANT: The Spray Gun must be cleaned every time immediately after use. Improper cleaning is the primary cause of Spray Gun failure.
2.Immediately after finishing painting, pour out remaining paint from the Cup. Rinse out the cup with paint thinner. Wipe out the cup to clean remaining paint residue. Fill the Cup part way with paint thinner and spray into a suitable container. Continue to spray until the thinner comes out clear.
3.Dump remaining thinner from the Cup back into the thinner container. Wipe off the exterior of the Spray Gun with thinner to remove paint.
4.If the gun becomes clogged, disassemble parts 1 - 7, 9
5.To clean, use the enclosed brush (33) or a cleaning kit, such as SKU# 99634 available from Harbor Freight Tools.
6.Never use a pin or metal scraper to clean the delicate components of this sprayer. You will damage the sprayer.
7.Carefully reassemble following the Assembly diagram on page 17. Be sure all springs and seals are prop- erly seated. Do not damage threads. Do not overtighten.
SKU 66222 | For technical questions, please call | Page 13 |
